5. Olfa cutter knife.

#1 Spray the outside of the driver and passenger glass, and wipe clean

#2 Spray the solution on the glass

#3 Carefully remove the tint

#4 Place the tint marked driver 
on the outside of the glass

#5 Spray the window with solution

#6 Gently scrub with pad

#8 Carefully peel off liner making sure film stays on the glass

#9 Slowly peel back, (spray the film while peeling)

#11 Pull the liner down evenly until you are 2" from bottom edge

#12 Make sure your hands and fingers are clean, before touching the film dip water

#13 Remove film and liner from outside of glass, be careful not to let the liner come off the film the rest of the way

#14 Place tint on the glass 1/16" from the edge on the top of the glass

#15 Spray solution on tint and squeegee water from tint starting at the top and working toward the edge. Work halfway down, wrap paper towel around squeegee and squeegee top edge pushing upward to absorb water (as shown in figure #23)

#17 Wet tint and flip up liner as shown

#18 Spray bottom edge thoroughly

#19 Place gasket tool between rubber and glass

#20 Remove the rest of the liner

#21 Squeegee water toward the bottom pulling back on the gasket as you go

#22 Spray window again and squeegee the entire window again, starting at the top working down and toward the sides (do not roll window down, start as high on glass as possible)

Repeat steps 1-23 for each window. 

#23 Wrap towel around squeegee, push down toward bottom to soak up solution being pushed from under tint